Contact Us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right. 

736 Southwest Umatilla Avenue
Redmond, OR, 97756
United States

5412133829

BLOG

mini-white part 2

Sean White

Now that we have some production molds to work with we can start pouring our slip.

IMG_1668.jpg

After the determined casting time we drain the slip and prop our molds on the drying table. These tubtrugs are super handy for slip and for plaster, we highly recommend them.

IMG_1678.jpg
IMG_1680.jpg

If the cup in the mold has a handle you'll probably want to drain the mold so the drain stream flows out over the handle, lessening the dimple inside the mug.

IMG_1681.jpg

After removal from the mold and some preparation we glaze the greenware in our spray booth.

IMG_1787.jpg

Then we load the kiln...

IMG_1794.jpg

These are the same cups, after firing, unloading, decaling, reloading and decal firing. 

IMG_1869.jpg

Look at this shrinkage!

IMG_1867.jpg

ENJOY!